I Took Apart My Supercharged Corvette Engine To Fix A MAJOR Factory Defect & Make It Fast Again!

Here's the VIN Check site. http://bit.ly/3hBRd93 You can check your VIN for Free! Don't buy a car without running it here first and share this with your friends and family. I can't stress enough how many clean title cars were wrecked and you'd never know!

In this video, I take apart the engine on my cheap supercharged Corvette to fix a major factory defect and make it fast again! We also discover even more about this car, go for a really easy drive never going over the speed limit or spinning the tires at all, and much more. What kind of Corvette do you drive? Let me know in the comments and enjoy the show!

Check out Petris Enterprises! His instruction are down below. https://petrisenterprises.com/collections/frontpage

Enter to win the C63 for FREE! https://modsandmiles.com/s/LSC
Check out the live listings at https://bit.ly/3yrKinI and list your car for Free!

Get 25% off all Amsoil products including their synthetic engine oil! https://legitoil.myamsoil.com/
Scroll down the page to "preferred customer" and click "learn more" to get the deal!

LSC Merch & New Signature series shirts including SVT Lightning & E55 AMG shirts and posters. https://www.legitstreetcars.com/ LEGIT1O For 10% Off!

Use Coupon Code LEGIT For 10% off Sonic Tools! Combine Code With Other Sales! https://bit.ly/3iNDtGU
Try a sample tool kit for only $60! https://bit.ly/3CSBqcB

Everything car-related I recommend from Amazon! https://amzn.to/2k606

Petris Opti Diagnosis
If you suspect an Optispark failure and do not have SES codes 16 low resolution pulse, 36 high-resolution pulse, PO1371 low-resolution pulse or 1372 high-resolution pulse, check for spark output using a spark tester and fuel injector pulse with a fuel injector noid light.

The ECM/PCM requires a pulse from the Optispark whether it be on the low or high-resolution circuit to set a code. Meaning that the ECM/PCM has to see one of the two pulses to set a code for the missing pulse. The exception would be 1996-1997 LT1-LT4 with a crankshaft position sensor, they would see crankshaft rotation with no Optispark output

If the Optispark has no output whatsoever the ECM/PCM does not know that the engine is in crank mode.

If you have one of the two, spark, no fuel injector pulse or fuel injector pulse, no spark the Optispark distributor is doing its job providing a low-resolution pulse. The next troubleshooting steps would be from the PCM to the ICM and/or ignition coil.

If you have neither spark or fuel injector pulse, the wiring from the Optispark to the ECM/PCM should be tested. A multi-meter should be used to check for Optispark input voltage, ground, low and high-resolution pulses in the .24 - 4.0 volt range at the ignition system test connector located at the middle of the intake manifold on the passenger side. If you find no output or one output the Optispark has failed.